:: Forums 
 ::
About us
 :: Customer Cars
 :: Contact us


 :: Buick Grand National
 :: Used Parts & Sales
 ::
Browse By Vendor
 :: See Entire Catalog


 
 Cottons Performance Center
 105 Walnut St.
 Agawam, MA 01001
 Ph:  (413) 789-0531
 Fx:  (413) 789-0401
 Email Us

 


 


Home » Casper's Electronics

 Checkout
V-Plus Volt Booster 86/87
Product ID: CASP-102027
V-Plus Volt Booster 86/87
 

Your alternator is designed to put out a specific voltage, generally 13.8 volts. The only problem is when there's a greater demand on the electrical system, such as a WOT blast, the alternator falls a little short. The V-Plus is designed to overcome voltage taper at WOT by stepping up the alternator voltage 2.2v. at 70% throttle. Result? More power to your fuel pump and ignition system. Unit plugs in, with no wires to cut or tap into. Includes hardware. Designed for 1986-1987 turbo powered Regals AND 1989 turbo Trans-Am.

Price: $79.95

Fuel Pump Wiring Upgrade
Product ID: CASP-102028
Fuel Pump Wiring Upgrade
 

Absolutely essential upgrade item for your turbo car! Increases fuel pump volume by 15% or more! By far the finest 12 gage "hotwire" kit on the market, this "Plug-And-Play" system uses a weather-tight sealed 30 amp relay and sealed OEM factory connectors throughout. Includes sealed fuse, braided gas tank ground strap and all hardware. Simple installation.

Price: $59.00

Fuel Injector Harness, High-Current
Product ID: CASP-102033
Fuel Injector Harness, High-Current
 
This harness is designed to feed low impedance injectors in race applications. Using direct feed from the positive bus, the system provides minimal power loss to the injectors and ensures full injector control.
Price: $129.95

Fuel Injector Harness 14 Gage - 86/87
Product ID: CASP-102037
Fuel Injector Harness 14 Gage - 86/87
 

Factory appearing Fuel Injector harness using 14 gauge wire, recommended for use in high performance racing applications where low impedance injectors are used.

Price: $109.00

Ground Stretcher Kit
Product ID: CASP-102040
Ground Stretcher Kit
 

Good grounds are absolutely essential for proper engine sensor operation. The factory located wiring grounds are less than adequate for long term stability. Our ground stretcher kit addresses the problem by relocating the grounds, extending the wiring, and providing braided ground connections to the engine and firewall. Used on 86-87 turbo cars ONLY.

Price: $42.00

Heated Oxygen Sensor Kit 1986/1987
Product ID: CASP-102042
Heated Oxygen Sensor Kit 1986/1987
 

Plug-and-Play kit installs in minutes with NO wires to cut or splice. Plug-in wire harness included in this kit. Its a known fact that additives in high octane fuel will damage your O2 sensor and affect driveability in short order. Our heated O2 sensor kit prevents deposits from sticking by "burning off" deposits, making the sensor live a longer life. Additionally, a heated O2 sensor helps cut emissions by becoming active faster than a non-heated unit, getting your engine into "closed-loop" sooner. Kit includes NTK four-wire sensor.

Price: $98.95

Fan Hi/Lo Switch
Product ID: CASP-102044
Fan Hi/Lo Switch
 

Plug-and Play manual coolant fan controller uses micro toggle switch and attaches to the coolant switch connector. Allows for manual control of the high and low coolant fan. Set the switch in one direction to override the chip control of the low speed fan, and set it in the other direction to manually set the coolant fan on HIGH. When in the hi position, fan will run for 5-10 minutes after car is shut off. Use for better control of engine heat.

Price: $46.95

Cam Tool
Product ID: CASP-102075
Cam Tool
 

Setting your cam sensor timing is critical to the timing of your fuel injectors. This plug-in tool makes adjustment a snap. Comes with two timing mark labels, instructions, and is self powered.

Price: $38.00

Cam Sensor Cap
Product ID: CASP-107112

Details 

New design provides a simple and accurate procedure to set the required 25 degree ATDC cam sensor signal. Has built-in LED which indicates an exact setting point. You simply rotate your engine to Top Dead Center and this cap does the rest. No need to index your crankshaft away from the timing mark!

Price: $79.95

XFI FLASH Selector Program
Product ID: CASP-108122

Details 

thumbwheel
Price: $59.95

Dual Fan Relay Upgrade Harness
Product ID: CASP-109069
Dual Fan Relay Upgrade Harness
 
Use this relay harness when installing a Ramchargers (Dodge) 674001 dual fan assembly. This takes the excessive electrical load off of the factory wiring and places it upon two separate sealed relays.NO CONNECTORS TO ADD. This harness is Plug-And-Play design.
Price: $79.95


 
Current Specials!


Shop Online Now! We Proudly Accept
 
 


Directions To Cottons Performance Center


Shipping & Return Information



Jack Cotton's 8.90 @ 154MPH 1986 Buick
 T-Type